GOC Technologies of Hawaii, Inc.   808-839-1300   Mon-Fri 7am - 4pm HST and Sat 8am - 12pm

Specifications
Overall Length	48"
Overall Width	40"
Overall Height	47"
Compactor Capacity	.5 cu. yd
Platen Area	20.5"x28.5"x29.5"
Charge Opening	20.5"x29.5"
Ram Penetration	4"
Twin Cylinders	2.5"x20"x1.5"
Line Pressure	2000 PSI
Max Line Pressure	2500 PSI
Max Ram Force	19500 LBS
Cycle Time	40 Seconds
Fluid Capacity	35 Gallons
Pump	5 GPM
Motor	5 HP/Tri-Volt, 3 Phase
Loading Height	41"
App. Shipping Weight	2900 LBS

Container Features

5/16" steel plate floor with 3" structural channels .25" steel plate sides with 3"x 2"x .25" structural steel tubing Breaker bar 6"x 6"x 1/2" with retaining teeth .5" steel plate hydraulic cylinder mounts Replaceable .5" UHMW polyethylene wear bars on all sides and bottoms for a smooth quiet and near frictionless operation Weatherproof control panel and power pack Removable rear access panel Container guide rails

Electric / Hydraulic Features

(PLC) Controlled Power Unit E-Stop Button Automatic Single Cycle Auto/Manual Selector Key Lock On/Off Switch Multi-Cycle 80% - 100% Full Lights Automatic Shutdown with Auto Safety Retract 15' Remote Low oil sensor shutdown Inlet Fluid Strainer Left or Right Side Hydraulic Connections

Receiver Container

4 yd Rear Load 6 yd Rear Load 8 yd Rear Load 4 yd Front Load 6 yd Front Load 8 yd Front Load

This Equipment Conforms to all ANSI Z 245.2 Safety Standards.

5 HP 220V 1 phase Fluid reservoir heater Driver pack out Open hopper (for loading dock or ground loading) Enclosed doghouse with door and interlock Walk on or drive on deck with 42" safety rails Side loading hoppers Through-the-wall chutes

NC-50 Schematics CLICK TO DOWNLOAD NC-50 Specifications (32K Word Document) NC-50 Minimum Tolerances PLAN (254K PDF) NC-50 Minimum Tolerances ELEVATION (258K PDF) NC-50 Dimensions PLAN (182K PDF) NC-50 Dimensions ELEVATION (396K PDF)